Inhaltsverzeichnis
Werbung
Ferm
.
.
,
.
.
,
.
,
,
,
o
Ferm.
.
.
.
64
,
.
ı
CE
EN-50144-1, prEN50144-2-3,
EN-55014-1, EN-55014-2,
EN61000-3-2, EN61000-3-3,
,
.
:
.
98/37EEC
73/23EEC
.
89/336EEC
16-12-2002
,
GENEMUIDEN NL
,
W. Kamphof
Quality department
,
.
INLAY SAWS
Fig.E
.
•
Inlay saws are only allowed in soft materials like
wood, cellular concrete, plasterboard, etc.
•
However, it demands a certain practice and can only
be done using short saw blades.
•
Place the saw onto the workpiece and switch on the
( GR )
machine.
•
Leave the bottom edge of the baseplate rest on the
workpiece surface, see figure.
•
Slowly saw at an angle in the workpiece, bring the saw
to a vertical position and continue sawing along the
:
saw line.
•
Switch off the machine and lift the workpiece when
the work is finished.
SURFACE SAWS
•
With elastic bimetallic saw blades it is possible to saw
off objects that are sticking out (like water pipes, iron
bars, etc.) level with the wall.
•
Place the saw blade directly against the wall and bend
it slightly so that the baseplate is resting against the
wall.
•
Switch on the machine and saw off the object, main-
taining a constant side pressure to the wall.
The machine has no parts that need maintenance. Quali-
fied maintenance engineers must carry out all repairs or
service activities.
MALFUNCTIONS
In case the machine does not function properly, there are
a number of possible causes and corresponding solutions
as described below.
1. The electric motor gets hot
•
The cooling air slits in the motor are blocked with
dirt.
Clean the cooling air slits.
•
The motor is broken.
Offer the machine to the Service department GSC
BVBA for checking and/or repair.
2. The running machine does not work
•
Interruption in the mains connection.
Check mains connection for breaking
Offer the machine to your Service department GSC
BVBA for checking and/or repair.
A qualified installer or repair company must always
carry out repairs.
Ferm
Ferm
MAINTENANCE
Make sure that the machine is not live when car-
rying out maintenance work on the motor.
The Ferm machines have been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon pro-
per machine care and regular cleaning.
Cleaning
Keep the ventilation slots of the machine clean to pre-
vent overheating of the engine.
Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots free
from dust and dirt.
If the dirt does not come off use a soft cloth moistened
with soapy water. Never use solvents such as petrol,
alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part, please con-
tact your local Ferm dealer.
In the back of this manual you find an exploded view
showing the parts that can be ordered.
ENVIRONMENT
In order to prevent the machine from damage during
transport, it is delivered in a sturdy packaging. Most of
the packaging materials can be recycled. Take these
materials to the appropriate recycling locations.
Take your unwanted machines to your local Ferm-
dealer. Here they will be disposed of in an environmen-
tally safe way.
5
Werbung
Inhaltsverzeichnis
