Maintenance - Ferm CTM1016 Originalbetriebsanleitung

Material Speed setting
Stone, shell -
Steel +
Aluminium, brass + -
Plastic -
Felt wheels and tip
Fig. 5
The felt wheels or tip should be screwed on the
mandrel.
Material Speed setting
Steel +
Aluminium, brass + -
Plastic +
Sanding bands and disc
Fig. 6
Material Speed setting
Wood + +
Steel -
Aluminium, brass + -
Plastic -
High speed cutter, Diamond wheel point and
Drill
Fig. 8
Material Speed setting
Stone, shell Max
Steel + -
Aluminium, brass + +
Plastic -
Abrasive disc
Fig. 9
Material Speed setting
Steel +
Aluminium, brass + -
Plastic -

5. Maintenance

Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the engine. Regularly clean
the machine housing with a soft cloth, preferably
after each use. Keep the ventilation slots free from
dust and dirt. If the dirt does not come off use a
soft cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Please clean the tool immediately after use.
Lubrication
The machine requires no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Damaged and/or disposed of electrical or
electronic devices must be dropped off at
recycling stations intended for that
purpose.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
EN
9