To Remove A Timer Setting From A Memory Slot; To Remove All Timer Settings; To Disengage And Engage A Timer Setting; To Use The Remote Control - Anslut 006859 Bedienungsanleitung

10
Press the SET button. "02" flashes in the display.
Note! "02" is the next memory slot for timer setting. Repeat
the steps above to do the timer settings for the next memory
slot. If it is not necessary to do more timer settings, wait until
the display returns to standard mode.
Note! The product has 4 memory slots for 4 different timer
settings per day.
11
Press the ON/OFF button. "P" and "OFF" shows in the
display. The product automatically starts to operate at
the set start time and stops at the set stop time.
4.8 To remove a timer setting from a
memory slot
The timer settings you make are automatically stored in the
memory slots of the product until you remove them. If it is
necessary to remove a stored timer setting, do the steps that
follow.
Note! You cannot use the remote control to remove timer
settings. Use the control panel.
1
Press the WEEK button again and again to show the
timer settings in the sequence that follows.
A. Single timer setting or reoccurring timer setting.
B. Preheating function ON/OFF.
C. Temperature.
D. Start time.
E. Stop time.
F. Next timer setting.
2
Press and hold the WEEK button.
3
Press the SET button until the number for the
required timer setting shows in the display.
4
Press and hold the SET button until you hear a short
sound. The timer setting is removed when you hear
the short sound.

4.9 To remove all timer settings

Note! You cannot use the remote control to remove timer
settings. Use the control panel.
1
Press and hold the WEEK button.
2
Press and hold the MOD button and the SET buttons
until you hear a sound. All timer settings are removed
when "88:88" shows on the display.
2022_001
4.10 To disengage and engage a timer
setting
A timer setting can be disengaged and engaged. Do the
steps that follow to disengage and engage a timer setting.
1
Press and hold the week button and the MOD button
until "TIME" goes off in the display. The timer setting
is disengaged.
2
Press and hold the MOD button until "TIME" shows
on the display. The timer setting is engaged.

4.11 To use the remote control

The remote control has 6 buttons that correspond to the
buttons on the control panel. (Figure 3)
Note! The MODE button corresponds to the MOD button on
the control panel.
The remote control operates in the same way as the control
panel but with the exceptions that follow.
● The + and - buttons cannot be used to adjust the output
when the product is in the "M" mode. Use the long button
to adjust output when the product is in "M" mode.
● The remote control has an ECO button. Press the ECO
button to put the product in energy saving mode. The
product keeps the room temperature at 16°C when it is in
energy saving mode. Press the ECO button again to exit
energy saving mode.
Note! You cannot do adjust settings when the product is in
energy saving mode.
Note! The product automatically exits energy saving mode
if a start time for a timer setting is reached. When the stop
time for the timer setting is reached the product stops.
5

Maintenance

5.1 To clean the product

Warning! Disconnect the product from the power out-
let before you clean or do maintenance on the product.
Warning! Let the product become cool before you
clean it. Engage a timer setting.
● Wipe the external parts of the product with a damp cloth
and a mild detergent.
Caution! Do not use abrasive detergents, wax or
polish on the product. Abrasive detergents, wax and polish
can cause damage to the product.
33