To Switch Between Modes; To Adjust The Temperature; To Use The Week Timer Function - Anslut 006859 Bedienungsanleitung

4.5 To switch between modes

The product has 2 modes, "P" mode and "M" mode. In "P"
mode you can adjust the temperature and the week timer. In
"M" mode you cannot adjust the temperature or week timer.
● Press the MOD button on the control panel to switch
between "P" mode and "M" mode.
Note! In "M" mode the + button starts the product and the -
button stops the product.

4.6 To adjust the temperature

1
Start the product. Refer to "4.2 To start the product"
on page 31.
2
Put the product in "P" mode. Refer to "4.5 To switch
between modes" on page 32.
3
Press the SET button until the standard temperature
"25°C" flashes in the display.
4
Press the + and - buttons until the required target
room temperature shows in the display.
Note! The temperature can be adjusted between 0–37°C.
5
Press SET. The product starts to warm up.
Note! The heater in the product will go on and off to keep
the temperature at the target room temperature.

4.7 To use the week timer function

1
Start the product. Refer to "4.2 To start the product"
on page 31.
2
Make sure that the date and time is correctly
adjusted. Refer to "4.4 To adjust the date and time" on
page 31.
Note! The week timer function will not operate correctly if
the date and time is not adjusted correctly.
3
Put the product in "P" mode. Refer to "4.5 To switch
between modes" on page 32.
4
Press and hold the WEEK button. "01" flashes in the
display.
5
Press the + and - buttons to select "01" to use a single
timer setting or "][" to use the reoccurring timer
setting.
32
Note! A single setting must be used within the present
week. Single settings are disabled on Sundays at 24:00.
Note! Timer settings are stored in 1 of the 4 memory slots
when they are disabled. To remove a timer setting from
a memory slot, refer to "To remove a timer setting from a
memory slot".
6
Press the SET button. "ON" flashes in the display.
7
Press the + and - buttons to engage ("ON") or
disengage ("OFF") the preheating function. The
preheating function controls the room temperature
20 minutes before the set time. The preheating
function will come on if it is necessary to adjust the
room temperature 1 or 2 degrees.
8
Do the steps that follow to adjust the start time for the
timer.
A. Press the SET button. "01 SET ON" shows in the
display.
B. Press the + and - buttons to adjust the required
date for the timer setting.
C. Press the SET button. The standard temperature
"25°C" flashes in the display.
D. Press the + and - buttons to adjust the required
target temperature.
E. Press the SET button. The numbers for the hours
flash.
F. Press the + and - buttons until the required hours
show in the display.
G. Press the SET button. The numbers for the
minutes flash.
H. Press the + and - buttons until the required
minutes show in the display.
9
Do the steps that follow to adjust the stop time for the
timer.
A. Press the SET button. "01 SET OFF" shows in the
display.
B. Press the + and - buttons to adjust the required
date for the timer setting.
C. Press the SET button. The numbers for the hours
flash.
D. Press the + and - buttons until the required hours
show in the display.
E. Press the SET button. The numbers for the
minutes flash.
F. Press the + and - buttons until the required
minutes show in the display.
2022_001