Introduction; Product Description; Intended Use; Symbols On The Product - Anslut 006859 Bedienungsanleitung

Table of content
1 Introduction
1.1 Product description ............................................28
1.2 Intended use .........................................................28
1.3 Symbols on the product .................................28
1.4 Product overview ...............................................28
1.5 Display overview ................................................28
1.6 Remote control overview ...............................29
2 Safety
2.1 Safety definitions ................................................29
2.2 Safety instructions for operation ...............29
3 Installation
3.1 To install the product ........................................30
4 Operation
4.1 To do before you use the product
for the first time ..............................................................31
4.2 To start the product ..........................................31
4.3 To stop the product ...........................................31
4.4 To adjust the date and time...........................31
4.5 To switch between modes ............................32
4.6 To adjust the temperature .............................32
4.7 To use the week timer function ..................32
4.8 To remove a timer setting from
a memory slot.................................................................33
4.9 To remove all timer settings .........................33
4.10 To disengage and engage
a timer setting ................................................................33
4.11 To use the remote control .............................33
5 Maintenance
5.1 To clean the product .........................................33
6 Storage
6.1 To put the product in storage .......................34
7 Disposal
7.1 To discard the product ......................................34
8 Technical data
28
1

Introduction

1.1 Product description

28
The product is an electric radiator that can be operated
manually or from a remote control. The product has a tilt
guard that stops the product if the product is not vertical. A
overheat protection function stops the product if the product
becomes too hot and starts the product when the product
has become cool.

1.2 Intended use

29
The product is intended to be used as an extra heat source
for a living space indoors. The product must be used when it
is installed to a vertical wall only.

1.3 Symbols on the product

30
31

1.4 Product overview

(Figure 1)
1. Air outlets
2. Air intakes
3. Control panel with LED display
4. Power switch
33
5. Remote control
6. Brackets
34

1.5 Display overview

(Figure 2)
34
1. Thermostat or week timer control is active.
2. Shows if the operation mode is active.
3. Shows if settings for date or time is active.
34
4. Shows if the product is on.
5. Shows if the product is off.
6. Shows the temperature.
7. Shows the time or settings for the week timer.
Read the operating instructions carefully
and make sure that you understand the
instructions before you use the product.
Save the instructions for future reference.
This product complies with applicable EU
directives and regulations.
Recycle as electrical waste.
2022_001