Installation; To Install The Product - Anslut 006859 Bedienungsanleitung

● Do not let children do maintenance on the product
without supervision.
● Do not put objects into the holes of the air intake or air
outlet. Risk of electric shock.
● Keep animals away from the product.
● Keep the packaging material away from children. Risk of
suffocation.
● Only use accessories and parts that are approved by the
manufacturer of the product.
● Only connect the product to a power outlet that is
correctly earthed. Speak to an authorized electrician if
you are not sure.
● Only connect the product to a power outlet that has a
maximum tripping current of 30 mA. Speak to an
authorized electrician if you are not sure.
● Make sure that the mains voltage corresponds to the
rated voltage on the type plate of the product. Speak to
an authorized electrician if you are not sure.
● Connect the product to a separate power circuit.
● Speak to an authorized electrician it the power plug does
not fit in the power outlet.
● Do not put the power cord under carpets or rugs where it
can be stepped or tripped on.
● Do not put the power cord around sharp corners or
edges.
● Do not put weights on the power cord.
● Do not stretch the power cord.
● Do not use the power cord to carry the product.
● Do not use the power cord to pull the power plug from
the power outlet.
● Do not put the power cord or the product on or near hot
surfaces.
● Make sure that air can circulate around all sides of the
product.
● Make sure that flammable materials does not touch the
product.
● Do not operate the product near flammable liquids, gas
or dust.
● Do not use an extension cord if it is not necessary. If it is
necessary to use an extension cord it must be earthed
and the cross-sectional area of wires must be
dimensioned for the power supply to the product.
● Make sure that the power switch is in the off position (0)
30
before you disconnect the power plug from the power
outlet.
● Disconnect the product from the power outlet when it is
not in operation.
● Disconnect the product from the power outlet before you
clean or do maintenance on the product.
● Let the product become cool before you clean it or do
maintenance on it.
● Let the product become cool before you put it in storage.
● Keep the product in a dry and closed storage, away from
children, when the product is not in operation.
● Clean the product regularly. Too much dust can cause
overheating and fire.
3

Installation

3.1 To install the product

1
Remove all packaging and stickers.
Warning! Risk of fire. Packaging and stickers are
flammable. Make sure that all packaging is removed before
you use the product.
2
Make sure that the product has enough space. The
product must have at least 30 cm of free space below
and on the sides. There must be at least 150 cm of
free space above the product. (Figure 4)
3
Mark the hole positions for the 2 top brackets on the
wall and drill 2 holes for applicable screw plugs.
(Figure 5)
Note! Make sure that the markings for the holes are level
before you drill the holes.
4
Install applicable screw plugs (A) in the 2 holes.
(Figure 6)
5
Install the 2 top brackets (B) and with screws (C) in
the screw plugs. Use a screwdriver.
Note! Make sure that you install the 2 top brackets so that
the cutouts point upwards and the short parts points away
from each other.
6
Install the longer end of the 2 bottom brackets to the
bottom of the product (D) with the small screws.
(Figure 7)
2022_001