How To Use The Accessories En; Important Application Instructions - Kärcher SC 1.030 Betriebsanleitung

opening the safety lock, there is a risk of scald-
ing.

Fill the boiler with a maximum of 1 liters of
fresh tap water.
Danger
If the boiler is hot, there is the risk of scalding as
the water may splash back during the filling proc-
ess! Do not fill any detergents or other additives
into the boiler!

Screw the safety cap back onto the device.

Insert the mains plug into a socket.

The orange indicator lamp goes out after ap-
proximately 8 minutes.
The steam cleaner is ready to use.
Turning Off the Appliance

Disconnect the mains plug from the socket.

Press the cover of the appliance connector
to the bottom and disconnect the steam plug
from the appliance connector.
Storing the Appliance

Illustration
– Put the extension pipes into the large aces-
sory compartments.
– Insert the manual nozzle and detail nozzle
onto each extension pipe.
– Put the round brush into the medium acesso-
ry compartments.
– Hook the floor nozzle into the parking position.
– Wrap the steam hose around the extension
pipes and insert the steam pistol into the
floor nozzle.
How to Use the Accessories

Important application instructions

Refreshing textiles
Prior to treatment with the steam cleaner, always
check the reaction of the textiles in an inconspic-
uous location: Steam at first, then let dry and
then check for colour or shape changes.
Cleaning of Coated or Lacquered Surfaces
When cleaning painted or plastic-coated surfac-
es, as found on kitchen and living room furniture,
doors, parquet; wax, furniture polish, plastic sur-
faces or paint can come loose or stains can be
created. When cleaning these surfaces, briefly
steam a cloth and wipe the surfaces with it.
Caution
Never direct the steam jet at glued edges as the
edge band may loosen. Do not use the steam
cleaner on unsealed wooden or parquet floors.
Cleaning of Glass
In case of low outside temperatures, especially
in the winter, warm up the window pane by slight-
ly steaming the entire glass surface. This will
prevent tensions on the surface which might lead
to glass breakage.
Caution
Do not direct steam onto the sealed locations of
the window frame to prevent damage.
You can use the steam gun without any addition-
al accessories, e.g.:
– to remove odours and wrinkles from hanging
clothes by steaming them at a distance of 10
to 20 cm.
– to remove dust from plants. Here, keep a dis-
tance of 20-40 cm.
– for moist dusting, by briefly steaming the
cloth and wiping the furniture with it.
The closer this nozzle is to the contaminated ar-
ea, the higher the cleaning effect, as the temper-
ature and the steam are highest at the nozzle
output. Especially suited for cleaning difficult ac-
cess locations, joints, fittings, drains, sinks, toi-
lets, blinds and heaters. Heavy limescale can be
drenched in vinegar prior to steam-cleaning. Let
the vinegar penetrate for about 5 minutes.
The round brush can be installed onto the detail
nozzle as an accessory. Attached brushes can
therefore be used to remove heavy soiling.
Caution
Not suited for the cleaning of sensitive surfaces.

Illustration
Attach the round brush to the detail nozzle.
Pull the terry cloth cover over the manual nozzle.
Especially well-suited for small washable areas,
shower stalls and mirrors.
Suited for all washable wall and floor coverings,
e.g. stone floors, tiles and PVC floors. Work
slowly on very dirty surfaces to allow the steam
to act on the dirt for a longer period of time.
Note:Detergent residue or care emulsions that
are still present on the surfaces to be cleaned,
can lead to smears when steam cleaned. How-
ever, these will disappear with repeated cleaning
procedures.
– 9
EN
Steam gun
Detail nozzle
Round brush
Hand nozzle
Floor nozzle
17