Daily Use - IKEA UDDARP Bedienungsanleitung

ENGLISH

Daily use

Doing this will keep your machine working at its BEST!
Remember to empty your water tank after each drying cycle.
Remember to clean your filters after each drying cycle.
(Refer to section Care & Maintanence).
1. Load laundry
Open the door and load garments. Always refer
to instructions on clothing labels and the max
loads indicated in the programme section.
Empty pockets. Make sure garments do not get
caught between the door and/or the door filter.
2. Close door
3. Press the button On/Off
4. Select the programme according to the laundry type.
5. Select the options, if necessary.
6. To start the cycle, press the Start/Pause button
7. At the end of the drying cycle, a buzzer will beep.
An indicator on the control panel signals the end of the cycle.
Pull the load out immediately to prevent the formation of
creases on laundry.
8. Turn the machine off by pressing the button On/Off
the door and pull clothing out.
If the machine is not switched off manually, after about a
quarter of an hour from the cycle end, the appliance turns off
automatically to save energy.
.
.
To download the full version visit www.ikea.com
If this last stage is not carried out immediately, some machines
and/or some programmes/options are equipped with Crease
Care system.
For some hours, after the end of drying, the drum rotates at
regular intervals to prevent the formation of creases. In case of
power failure, it is necessary to press the button Start/Pause
to restart the cycle.
OPENING OF THE DOOR DURING THE CYCLE
During operation, it is possible to open the door.
After having closed it, press the button Start/Pause
restart the dryer.
, open
7
again to