Outboard Engine Kit Installation; Packaging Content - Veratron VMH 35 MARINE DISPLAY Bedienungsanleitung

OUTBOARD ENGINE KIT
INSTALLATION
Before beginning, disconnect the negative terminal on the battery, otherwise you risk a short circuit.
If the vehicle is supplied by auxiliary batteries, you must also disconnect the negative terminals on
these batteries! Short circuits can cause fires, battery explosions and damages to other electronic
systems. Please note that when you disconnect the battery, all volatile electronic memories lose their
input values and must be reprogrammed.
• The IBS must be mounted and handled in an ESD protected area
• The IBS may not be contaminated with foreign particles (e.g., oil, silicon, grease, coolant, etc.)
• The IBS may not be damaged
• The pole clamp may only be torqued to the battery pole

PACKAGING CONTENT

1x VMH35 Display
1x Wire Harness
1x Intelligent Battery Sensor
1x Pole Adapter
HARNESS
A
A VMH35 Connector
B EasyLink Connector
C Ignition (yellow/black)
D Ground (black)
E Resistive sensor signal - RES 1 (Trim)
(blue)
F Frequency Input (grey)
WARNING
B000855
B001066
B000842
B000684
B
G Alarm Output (white)
H Day/Night switch (red/white)
I Ring Connector for battery plus (with fuse)
J IBS Connector
K Resistive sensor signal - RES 2 (Fuel Level)

OUTBOARD ENGINE KIT INSTALLATION

J
K
C
D
E
F
G
H
I
B001167