Veratron VMH 35 MARINE DISPLAY Bedienungsanleitung Seite 12

OUTBOARD ENGINE KIT INSTALLATION
INSTALLATION
Cable installation
Pull in the cables ends through the boat's cable
channels.
Refer to the wire harness description in the previous
section to see which end must lead to which place.
IBS installation
Remove the connection to the negative pole of the
battery and attach the Intelligent Battery Sensor (IBS)
onto the terminal instead. Use a torque key to adjust
the tightening force to 5±1 Nm.
Connect the red ring type connector to the positive
pole of the battery.
Plug in the dedicated IBS connector into the sensor.
Make sure, the contacts lock audibly into place to
preserve the water tightness.
Fuel Level Sensor Connection
Connect the resistive output to the fuel level tank.
The plug installed on the wire harness matches the
Veratron Fuel Level Sensors.
In case your sensor doesn't fit cut of the connector and
crimp the fitting connection to the wires ends.
(The black wire is the sensor ground connection while
the green is the sensor signal.)
B001167