CALIBRATE THE SENSORS
Fuel level sensor
•
Connect the sensor of interest. See Connecting an analogue sensor.
•
Under Sensors select the resistive input to which the sensor is connected.
•
Under Fuel > Sensor, choose the desired configuration type.
•
If you have chosen the CUSTOM configuration, follow the wizard on the display to create the sensor
curve.
•
Under Sensors select the resistive input of step 2.
•
Under Fuel > Tank no., select the ID to be assigned to the tank to which the sensor is connected.
Fresh water level sensor
•
Connect the sensor of interest. See Connecting an analogue sensor.
•
Under Sensors select the resistive input to which the sensor is connected.
•
In Fresh water > Sensor choose the desired configuration type.
•
If you have chosen the CUSTOM configuration, follow the wizard on the display to create the sensor
curve.
•
Under Sensors select the resistive input of step 2.
•
Under Fresh water > Tank no., select the ID to be assigned to the tank to which the sensor is connected.
WASTEWATER LEVEL SENSOR
•
Connect the sensor of interest. See Connecting an analogue sensor.
•
Under Sensors select the resistive input to which the sensor is connected.
•
In Wastewater > Sensor choose the desired configuration type.
•
If you have chosen the CUSTOM configuration, follow the wizard on the display to create the sensor
curve.
•
Under Sensors select the resistive input of step 2.
•
Under Fresh water > Tank no., select the ID to be assigned to the tank to which the sensor is connected.
RUDDER ANGLE SENSOR
•
Connect the sensor of interest. See Connecting an analogue sensor.
•
Under Sensors select the resistive input to which the sensor is connected.
•
In Rudder choose the desired configuration type.
•
If you have chosen the CUSTOM configuration, follow the wizard on the display to create the sensor
curve.
TRIM SENSOR
•
Connect the sensor of interest. See Connecting an analogue sensor.
•
Under Sensors select the resistive input to which the sensor is connected.
•
In Trim follow the wizard on the display to create the sensor curve.
RPM SENSOR
•
Connect the sensor of interest. See Connecting an analogue sensor.
•
In Sensors > RPM > Config enter the value of pulses/revolution required for a correct reading of the
signal.
SENSOR CONFIGURATION
B001167