Veratron VMH 35 MARINE DISPLAY Bedienungsanleitung Seite 13

OUTBOARD ENGINE KIT INSTALLATION
Mount the VMH 35
Install the VMH 35 into the hole in the dashboard.
Please refer to the section "VMH 35 installation" to get
more information about the installation requirements.
EasyLink Satellites
If you have additional VMH 14 satellite gauges, install
them on the dashboard as well and connect them to
the EasyLink-connector.
The EasyLink standard allows up to 16 satellites in one
daisy chain.
Further cable connections
Make the connections with the bullet terminals
beneath the dashboard to the ignition, ground, the
tachometer signal and the trim sensor.
In addition, you can connect the remaining wire ends
of the harness to an alarm and a light switch.
Stick to the pinout described in the previous section.
Reattach Power
Connect the systems main ground connection, that
has previously been attached to the negative pole of
the battery, onto the IBS using the pole adapter.
Configure Settings
In order to see all the data on the display you'll have to
do the following VMH35 configurations.
Define Resistive Input 1 as trim.
Define Resistive Input 2 as the fuel level
Activate the IBS and define the according battery
instance.
For further instructions on how to make those
configurations refer to section "General Settings".
B001167