Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.7 Analog1 / Analog2
Instead of a digital signal, an analog voltage between 0...5V can also be applied to the respective
connection to control setpoint and brake (recuperation). This allows especially in vehicles to cont-
rol the power via one or two potentiometers (accelerator and brake pedal).
6. Installation and commissioning
6.1 Notes on installation
-
Make sure that the controller is protected against vibrations. If necessary, use small rubber
buffers to decouple it.
-
Make sure that the controller is cooled sufficiently. Good ventilation or an additional fan is
recommended. The cooler the controller is, the more efficiently it can operate.
-
The connection to the motor as well as to the voltage source should be as short as possib
le. Use only high quality connectors to minimize contact resistance.
6.2 Connection of the controller
-
The connection to the motor as well as to the voltage source should be as short as
possible. Use only high quality connectors to minimize contact resistances.
-
Connect the terminals U - V - W with the 3 phases of the BLDC motor.
-
Connect the positive and negative leads to your voltage source
Brushless DC Controller HST-50
Orginal operating manual
Communication interfaces / Installation and commissioning
Page 37 of 48
Rev1.2
Werbung
Inhaltsverzeichnis
