Using The Usb Interface; Accessories - Hacker HST-50 Betriebsanleitung

7.3.2 Using the USB interface

Basically, you have the possibility to use the complete range of functions of
the user interface via USB. To do this, connect the controller to your com-
puter using a suitable USB cable. The driver should now install itself. Now
select the appropriate COM interface and press „Connect". Then continue
as described in 7.

8. Accessories

To be able to use the extended range of functions, you may need
additional connectors. According to point 2, 4-pole and 5-pole plugs
are used on the HST-50 controller to control the different interfaces.
These socket housings and the matching crimp contacts with cable
can be purchased separately.
For the connection of a BLDC motor via the 3 phases we
recommend the use of 4mm gold contact plugs. These
can then be plugged directly into the sockets provided on
the controller side.
Brushless DC Controller HST-50
Orginal operating manual
Operation of the graphical user interface / accessories
Page 45 of 48
Rev1.2