Mounting And Commissioning; Installation And Commissioning; Connection Of Phase And Battery Cables - Hacker HST-120 Betriebsanleitung

4 Mounting and commissioning

4.1 Connection of phase and battery cables

You have to take care of the cabling between controller and motor as well as controller and battery
yourself.
Make sure that the cross-sections are suitable for the power.
The phase and battery cables are to be fastened with M5 nuts (tightening torque 1.6Nm).
Attach suitable ring or tube cable lugs to the cables for this purpose.
+ L3
NOTE
Unintentional loosening
To prevent unintentional loosening of the screw connection, select a suitable screw
locking device (spring washer, lock nut, etc.).
NOTE
Distance between cable lugs
Make sure that the cable lugs do not touch each other.
INFO
The cables should be kept as short as possible, especially between the controller
and the motor.
Brushless DC Controller HST-120
Orginal operating manual
L2 L1 -
Mounting and commissioning
Page 32 of 45
Rev1.3