Hacker HST-50 Betriebsanleitung Seite 41

- Then switch from the „Control" submenu to the „Motor" menu and press „Read Config" as
well.
Now switch back to the „Control" tab to get an overview of the motor data.
You now have the possibility to drive the motor according to the modes described under point 4.
For this purpose, a selection of buttons is available at the right edge of the GUI.
In the fields below you can see the current status of the system and any error messages.
Brushless DC Controller HST-50
Orginal operating manual
Operation of the graphical user interface / accessories
In the upper area you set the mode: PWM (voltage controlled), RPM
(speed controlled), CC (current controlled) and CB (recuperation)
can be selected. The preselected mode is displayed in blue.
According to the preselection, you can enter the value with which
you want to operate the motor in the field below.
Here as an example we have preselected 15A for Set 1, 30A for Set
2.
By pressing the respective set button, the motor is operated.
You can end your test by pressing the „Stop" key, the motor will
coast to a stop. „Full brake" generates an immediate braking of the
motor until standstill.
As a rule, we have already imported a
configuration file for you. If not, you can
import it into the controller via „Open
Config" and then „Write Config". Check
the correctness of the imported data with
the „Read Config" command. The system
is now ready for operation.
You can save your settings on your PC
with „Save config".
Page 41 of 48
Rev1.2