Hacker HST-50 Betriebsanleitung Seite 39

- Now establish a connection to the controller by first selecting the adapter in the upper right
corner with which you want to establish the connection, here HCan (HerSi-USB to Can
Adapter) and click on the „Connect" button. Now an additional orange LED should light up
on the adapter.
- To check the correct connection to the controller, press „Scan".
The GUI should now confirm the connection to the controller with „Found devices: 1" and
display the ID. The green dot next to „Founde devices" should light up statically.
- The controller is now ready for operation.
Brushless DC Controller HST-50
Orginal operating manual
Installation and commissioning
Page 39 of 48
Rev1.2