Installation And Commissioning; Mounting And Commissioning; Phase And Battery Cable Connection; Sensor Cable Connection - Hacker HST-70 Betriebsanleitung

4

Mounting and commissioning

4.1 Connection of phase and battery cables
You have to take care of the cabling between controller and motor as well as controller and battery yourself.
Make sure that the cross-sections are suitable for the power.
The phase and battery cables are to be fastened with M4 nuts (tightening torque 1.2Nm).
Attach suitable ring or tube cable lugs to the cables for this purpose.
NOTE
Unintentional loosening
To prevent unintentional loosening of the screw connection, select a suitable screw
locking device (spring washer, lock nut, etc.).
NOTE
Distance between cable lugs
Make sure that the cable lugs do not touch each other.
INFO
The cables should be kept as short as possible, especially between the controller
and the motor.
4.2

Sensor cable connection

Pin Signal
1 Temp
2 Enable
3 Power supply for hall
sensors
4 Hall C
5 Hall B
6 Hall A
7 PPM
8 ADC
9 CAN L
10 CAN H
11 GND ISO
12 GND
Brushless DC Controller HST-70
Orginal operating manual
Function V
DC
Input (Analog) 5V
Input (Digital) 9-58,8 V
Output (Load) 5V
max. 50mA
Input (Digital) 5V
Input (Digital) 5V
Input (Digital) 5V
Input (Digital) 5V
Input (Analog) 0-5V
CAN Bus <36V
CAN Bus <36V
GND ISO 0V
GND 0V
Mounting and commissioning
Top view Molex MX120G
Page 28 of 38
Rev1.2