Operation Of The Graphical User Interface - Hacker HST-50 Betriebsanleitung

7. Operation of the graphical user interface

- After you have successfully connected the controller and put it into operation, you can cont
rol the motor via the GUI. To do this, first press the Start Cont- rol button, the screen shown
above should then appear.
- Now check the current configuration of the system. To do this, go to the „Configuration" /
„Control" / „General" tab and press the „Read Config" button. Read Config" displays the
parameters that are currently on the controller.
- Make sure that under „Control
application" the item CAN1 is
marked, if not, mark it and then
press „Write config". Now the
system can be controlled comple
tely via CAN bus.
Brushless DC Controller HST-50
Orginal operating manual
Operation of the graphical user interface / accessories
Page 40 of 48
Rev1.2