Intended Use - Hilti DX 9-ENP Original Bedienungsanleitung

Display
3.8 Bluetooth
®
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc and any use
®
of such marks by Hilti Corporation is under license.
3.8.1

Intended use

This product is equipped with a Bluetooth
and the transfer of settings and data based on Bluetooth
which the two Bluetooth-enabled products can communicate with each other over a short distance. This
product is designed to enable communication and data transfers between smart phones and Hilti gateway.
The tool can submit data attributes such as location of the receiving device, runtime, total application count,
application count during interval and timestamp of transfer. Information about the connectivity functions
offered can be found in the respective Hilti application (app) or in the operating instructions of the tool you
are using.
3.8.2 Data transmission via Bluetooth
The data transmission interval can vary depending on the available power source of the tool and the status of
the tool. The signal range may vary greatly depending on external conditions, including the receiving device
used. The Bluetooth range may be significantly weaker inside closed rooms and through metallic barriers
®
(e g. walls, shelving units, cases, etc.). Depending on ambient conditions, several transmission intervals may
be required before the tool is detected.
If the tool is not detected, check the following:
• Is the distance to the mobile terminal device too great?
→ Reduce the distance between the mobile terminal device and the tool.
3.8.3 Installing and setting up the app
In order to be able to use the connectivity functions, you first have to install the respective Hilti app.
(1.) Download the app from the corresponding app store (Apple App Store, Google Play Store).
You will require a user account on the corresponding app store to do this.
(2.) After starting the app for the first time, please either log in with your account or register.
(3.) The display of your mobile terminal device will show you all the subsequent steps required to connect
the tool to the mobile terminal device.
First, fully complete the tutorial for the app. This will give you a better overview of how the connection
is made and how the connectivity functions are used.
3.9 Requirements to be met by cartridges
WARNING
Risk of injury by unexpected explosion!
requirements can lead to a build-up of unburned powder. A sudden explosion and severe injuries to the
operator and bystanders can result.
▶ Use only cartridges that meet the minimum safety requirements of your local statutory regulations!
▶ Adhere to the maintenance intervals as stated and have the fastening tool cleaned regularly by Hilti-
Service!
Use only the Hilti DX cartridges listed in this table, or other suitable cartridges that are compliant with the
minimum safety requirements:
28 English
Explanation
The black square at the lower edge on the right indicates that demo
mode is active. In this case, the information in the display does not
reflect the actual status of the tool.
The Hilti Connect smartphone app can be used to deactivate the
demo mode. Demo mode is automatically deactivated after a period of
15 minutes.
Low Energy Module which enables the status checking of a tool
®
wireless technology, a data transfer system by
®
®
Use of cartridges that do not meet the minimum safety
2241307
*2241307*