Intended Use - Hilti PS 200 S Bedienungsanleitung

▶ Store idle power tools out of the reach of children and do not allow persons unfamiliar with the
power tool or these instructions to operate the power tool. Power tools are dangerous in the hands
of untrained users.
▶ Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and
any other condition that may affect the power tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by poorly maintained power tools.
▶ Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
▶ Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking
into account the working conditions and the work to be performed. Use of the power tool for
operations different from those intended could result in a hazardous situation.
Battery tool use and care
▶ Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used with another battery pack.
▶ Use power tools only with specifically designated battery packs. Use of any other battery packs may
create a risk of injury and fire.
▶ When battery pack is not in use, keep it away from other metal objects, like paper clips, coins,
keys, nails, screws or other small metal objects, that can make a connection from one terminal to
another. Shorting the battery terminals together may cause burns or a fire.
▶ Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.
Service
▶ Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
2.2 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not take apart, squash or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not attempt to charge or continue to use damaged batteries.
▶ If the battery is too hot to touch, it may be defective. In this case, place the power tool in a non-flammable
location, well away from flammable materials, where it can be kept under observation and left to cool
down. Contact Hilti Service after the battery has cooled down.
3 Description
3.1 Overview 1
PS 200 S scanner
@
PSA 60 soft pouch
;
PSA 55 infrared adapter
=
PSA 63 hand strap
%
PSA 92 USB data cable
&
PSA 93 headset / microphone
(
PSA 64 soft pouch
)
PSA 80 battery
+

3.2 Intended use

The product is designed to be used for locating reinforcing bars in concrete, measuring depth of concrete
cover and estimating the diameter of the bars in the uppermost layer in accordance with the specifications
detailed in the technical data provided in these operating instructions.
3.3 Applications
The product can be used for various non-destructive detection applications on steel-reinforced concrete
structures (e.g. locating reinforcing bars in the uppermost layers, measuring depth of concrete cover and
estimating the diameter of the bars detected). The scanning mode used depends on the application. These
fall broadly into the following categories:
28 English
Printed: 14.11.2016 | Doc-Nr: PUB / 5314765 / 000 / 00
PUA 81 AC adapter
§
PUA 80 charger
/
PSA 10/11 reference grid set
:
PUA 90 adhesive tape
∙
Folding rule
$
PSA 70 brush
£
PUA 70 marking pen set
|
PS 250 toolbox
¡