Commissioning And Operation - Klarstein METROBREEZE ROM Bedienungsanleitung

EN
32

COMMISSIONING AND OPERATION

Setting the off timer
Press the timer key while the unit is running. The timer indicator light turns on
and the display flashes „00" 5 times in succession. During this time, press one of
the arrow keys to set the timer to a time between 1 and 24 hours. Between 1 and
24 hours, adjust the time in 1-hour increments. Once the set time has elapsed, the
unit will automatically turn off.
Setting the on timer
Press the timer key in standby mode. The timer indicator light turns on and the
display flashes „00" 5 times in succession. During this time, press one of the arrow
keys to set the desired time, just as you would for the off timer. While setting
the timer, you can also set the desired mode in which the timer should run after
switching on. If you select cooling, you can also enter the desired temperature. If
you select dehumidification, you can enter the desired humidity. After the entered
time has elapsed, the device starts automatically and runs in the set mode.
Changing the entered timer time / Switching off the timer
Press the timer key while the timer is already running. The display flashes and
shows the remaining time. Use the arrow keys to adjust the time as desired. Press
the timer button again while the display is flashing to turn off the timer.
Cooling and heating mode
• In the on state, press the mode button and select the cooling mode (COOL) or
heating mode (HEAT). The corresponding indicator light in the display turns
on.
• Press the arrow keys to set the temperature between 18 °C - 30 °C. Each time
the key is pressed, the set temperature increases or decreases by 1 °C.
• Press the speed key (SPEED) to select the speed in the following sequence:
high (HIGH) > medium (MID) > low (LOW).