Commissioning And Operation - Klarstein METROBREEZE ROM SMART Handbuch

EN
32

COMMISSIONING AND OPERATION

Setting of timer off
When the air conditioner is running, press this button, the timer LED lamp is on, and
meanwhile 88 Nixie tube will flicker "00" for 5 times, at the moment, press UP and
DOWN to adjust time from 1h to 24h. Between 1~24h of timer, up/down adjustment
once changes 1h. When the set time expires, the air conditioner turns off automatically.
Setting timer on
When the air conditioner is in standby state, press TIMER, the timer LED lamp is on, and
meanwhile the display will flicker "00" for 5 times, at the moment press UP/DOWN to
adjust the desired time, and the method of adjustment is the same as that during timer off.
During setting of timer, the operating modes after start can be selected, if COOL mode
is selected, the set temperature can be adjusted simultaneously; if DEHUMIDIFY mode is
selected, the set humidity can be adjusted simultaneously. After the set time expires, the
air conditio- ner starts automatically and runs in the selected operating mode.
Change of the set time / Turning the timer off
In the running process of timer, if you are intended to change the existing timer, you can
press TIMER once, at the moment 88 Nixie tube will flicker and display the remaining
time, during flicker pressing UP/DOWN can increase/decrease time on the basis of
the original time. If you press TIMER again during flicker, the set time will be cancelled,
namely timer quits.
COOL mode
• In on or timer on state press MODE to select COOL mode. At the moment the
corresponding LED on panel displays.
• Press UP/DOWN to set appropriate temperature in a range of 18~30°C (64-
86°F). When UP or DOWN is pressed once, temperature will go up or down by
1°C or 1°F every time.
• Press SPEED to select appropriate speed, and LOW, MID and HIGH speeds can be
circularly selected.