Use And Operation; Cooling Mode; Dry Mode - Klarstein PURE BLIZZARD SMART 7K Handbuch

USE AND OPERATION

Sleep Mode
After two hours of operation, the set temperature automatically increases by 1 °C.
After another 2 hours of operation, the set temperature increases again by 1 °C. The
temperature then remains the same and the fan runs at low speed.

Cooling Mode

If the room surrounding temperature is higher than the setting temperature, the cooling is
starting. If the room surrounding temperature is higher than the setting temperature, the
compressor stops and only the fan motor remains working at the set fan speed.

Dry Mode

In the dry mode, if the ambient temperature ≥17 °C, the compressor will start. Then,
the unit is controlled in the following manner: when the ambient temperature ≤15 °C,
the compressor shuts down. When the ambient temperature rises to be ≥17 °C, the
compressor starts again. The start/stop of the compressor meets the requirement for
3-minute protection time.
Fan Mode
Under the fan mode, fans runs on both high speed or low speed. Temperature setting is
in vain, unit just displays environment temperature between 10-35 °C.
Temperature Setting
The up button and down button may be used to change the set value of the temperature.
Timer Setting
• Press the Timer button to enter timed shutdown. Upon shutdown, press this button
to enter timed start. In the meanwhile, the timer indicator illuminates. Press the Timer
button to enter timed start/timed shutdown. Adjust the up or down button to set the
timing time. The time will cycle in the order of 1 to 24 to 1. The adjustment time of
the timing function is relative time.
• After timed start is set, once the timed start time is reached, the unit will start. In
the meanwhile, the timer indicator will extinguish and the ambient temperature is
displayed.
• After timed shutdown is set, once the timed shutdown time is reached, the unit will
shut down. In the meanwhile, the timer indicator will extinguish and the ambient
temperature is displayed.
EN
39