Venting The System - BestWater Jungbrunnen 25-00 ULTIMATE Gebrauchsanleitung

Venting the system

During initial start-up or new start-up,
both water paths (cold and hot) must be
vented. Place a vessel with a capacity of
approximately 1 liter under the outlet
tap.
Now deactivate the
lights up blue when activated) and then
tap the cold water button. The pre-
vailing pressure in the system will now
remove air bubbles and water equally
from the system. Let the water run until
the pure water flows out of the outlet tap
in a continuous, even stream.
JUNGBRUNNEN 25-00
The cold water line is now vented.
Now repeat the process with the „hot"
water path.
Caution: The venting of the hot water
path does not require a storm from the
heating system switch.
The venting is done with cold water.
The switch for the heating system may
only be operated after venting.
Now deactivate the
activated it lights up blue) and then tap
the hot water button. The prevailing
pressure in the system will now expel air
bubbles and water alike. Let the water
run until the ultrapure water flows out
of the outlet tap in a continuous stream.
Only when you have made sure that the
ultrapure water flows out in a steady,
even stream is the system completely
deaerated and you can switch on the
heating in the next step.
lock button (it
lock button (when
Setting Up and Connecting
Switch on the heating system
On the back of the 25-00 ULTIMATE, turn
on the second red switch, of the heating
system to heat the filtered water.
Operating switch & the heating unit switch
Switch heating unit
Operating switch
How to tap water
You can use the ultrapure water in three
ways:
Hot water
●
Cold water
●
Water with bubbles
●
When you tap the
device beeps twice in quick succession
and switches to unlocked mode.
The device remains in this state for ap-
prox. 7 seconds. During this period, the
lock button is no longer illuminated
and the device is ready for further inputs.
After the 7 seconds, the
lights up blue again and the lock is ac-
tivated again and blocks entries on the
control panel.
Draw hot or cold water.
To get hot water, first tap the
button. This will cause the unit to beep
twice in quick succession and the unit's
protection mechanism will be disabled
for a few seconds.
Now you can press the
button. The unit now conveys the ultra-
pure water through the heating element
and dispenses it at the tap. The water
/ON
/ON
lock button, the
lock button
lock
hot water
53
EN