BestWater Jungbrunnen 25-00 ULTIMATE Gebrauchsanleitung Seite 47

The water stopper
Follow these steps to connect the water
stopper:
1. Open the rear battery cover of the
water stopper. Insert one AA battery
into the water stopper and close the rear
battery case again. Change this battery
after each filter change, or once per year.
2. Screw the 1/4" plug-in connector IT
onto the 3/4" y-distributor.
3. Screw the water stopper onto the 3/4"
Y-distributor finger-tight. A washing ma-
chine or dishwasher can also be connec-
ted to the Y-distributor.
JUNGBRUNNEN 25-00
4. Make sure that the contaminant fil-
ter is installed in the water stopper.
5. Mount the water stopper with the Y-
distributor onto the corner valve of your
cold water connection and
6. Connect the third sensor to the other
sensors and place the water stopper
sensor in the deepest part of your built-
in cupboard.
Water-Stopper installed on the corner valve
Setting Up and Connecting
The electrical connection
The BestWater system is equipped with a
cold appliance socket on the back, which
includes an integrated fuse. The scope of
delivery includes a cold appliance cable
with a length of approx. 1.8 m.
The accessibility of the mains plug must
always be ensured in order to disconnect
the BestWater system from the mains
supply.
Connect the BestWater system with the
supplied cold appliance cable.
Electrical connection
4
5
3
2
6
1
Cold appliance plug
The connection may only be made to an
electrical system designed in accordance
with VEM 0100.
The rating plate provides information on
the rated input and the corresponding
type plate provides information.
Compare the data on the type plate with
the data of the electrical network.
The hose connections
Use these images to install the hose con-
nections onto the Jungbrunnen 25-00
ULTIMATE, and follow these steps:
Insert the plug sockets into the bulk-
head connector on the side of the Jung-
brunnen 25-00 ULTIMATE.
EN
47