The Control Panel - BestWater Jungbrunnen 25-00 ULTIMATE Gebrauchsanleitung

Push the filter unit back into the system
and close the maintenance door.
Push in the filter unit
JUNGBRUNNEN 25-00
Once you have completed this part of
the commissioning, continue with the fil-
ling of the system.
Switch on the Operating switch
There are two red switches on the back
of the 25-00 ULTIMATE, these are the
ON/OFF switches of the system the ope-
rating switch and the heating switch for
heating the filtered water. ONLY operate
the switch for the operating switch.
Operating switch & the heating unit switch
Switch heating unit
Operating switch
After you have done this, the
status will light up blue on the control
panel and the blue light on the outlet
tap will also start to light up. In addition,
the booster pump in the device begins
to build up
Setting Up and Connecting

The control panel

You can make various settings via the
control panel. It controls which type of
water (hot, cold or sparkling) is to be dis-
pensed.
It is also used to control the deaeration
of the system (see the following point).
The control panel shows the status of
the system. It can indicate whether it is in
heating or cooling mode, and whether
there is hot or cold water or both.
Control panel detail view
Legende
 Control panel (with status LED)
 Button - unlock
 Button - carbonated Water
As soon as you turn on the unit (in the
previous point bubble switch on the
back).
The unit will start to build up water pres-
sure inside the unit and the cooling unit
/OFF
will immediately start to work and cool
/ON
down the water.
The following table provides information
about the individual states of the unit,
CHILLING
how they are displayed and what is hap-
pening inside.

Status LED
 
 
 Button - hot Water
 Button - cold Water
EN
51