BestWater Jungbrunnen 25-00 ULTIMATE Gebrauchsanleitung Seite 45

The drain
The drain of the BestWater system can
be applied to all 40 - 50 mm thick plastic
hoses with ease.
Figure out where you will set up the drain
clamp before installation.
Note that the water drain should be vi-
sible once completely installed.
Drain drilling Frontview
(with marks)
JUNGBRUNNEN 25-00
Drainclamp install Sideview
1.
Foam rubber gasket
( 7 mm Ø hole)
Screw
Drainclamp 40 mm Ø
( 1/4" plug-in connector)
3.
Drain-hose 1/4"
Plug-in connector 1/4"
Setting Up and Connecting
After you have determined where the
drain clamp will be installed, drill a hole
above the air trap with a 7 mm drill bit.
Remove the residue after drilling.
Fasten the clamp to the trap.
Turn the screws equally among the
drain installation kit.
No additional fittings (depressurisers,
check valves, etc.) may be installed on
the hose to the drain clamp.
Mother
Drainclamp installed Frontview
(with installed Drain-hose)
2.
EN
45