Residual Risks; Package Contents - DeWalt DW743N QS Originalanweisungen

Additional Safety Rules for Table Saws
• Rebating, slotting or grooving is not allowed.
• Always use the push stick. Never cut workpiece smaller than
50 mm.
• Without additional support the machine is designed to accept the
maximum workpiece size of:
– Height 62 mm by width 600 mm by length 1500 mm
– Longer workpieces need to be supported by suitable additional
table, e.g. DE3497 or DE3472.

Residual Risks

The following risks are inherent to the use of saws:
– injuries caused by touching the rotating parts
In spite of the application of the relevant safety regulations and the
implementation of safety devices, certain residual risks cannot be
avoided. These are:
– Impairment of hearing.
– Risk of accidents caused by the uncovered parts of the rotating
saw blade.
– Risk of injury when changing the blade.
– Risk of squeezing fingers when opening the guards.
– Health hazards caused by breathing dust developed when sawing
wood, especially oak, beech and MDF.
The following factors are of influence to noise production:
– The material to be cut.
– The type of saw blade.
– The feed force.
The following factors increase the risk of breathing problems:
– No dust extractor connected when sawing wood.
– Insufficient dust extraction caused by uncleaned exhaust filters
– Worn saw blade.
– Workpiece not exactly guided.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Never use the mitre saw when the guard is not in place.
✔
When using the machine in the mitre saw mode, make sure
to operate the trigger switch when switching on and off. Do
not operate the switchbox in this mode.
When using the machine in the bench saw mode, make
sure that the riving knife has been mounted. Do not use the
machine without the riving knife.
Do not use the riving knife when using the machine in the
mitre saw mode. Make sure that the riving knife is secured in
the upper rest position (fig. A2).
Carrying point
DATE CODE POSITION (FIG. A1)
The Date Code (39), which also includes the year of manufacture, is
printed into the housing.
Example:
2012 XX XX
Year of Manufacture

Package Contents

The package contains:
1 Partly assembled machine
4 Legs
1 Saw blade
1 Box containing:
1 Top guard for bench saw position
1 Under-table guard for mitre saw position
1 Parallel fence
1 Push stick
1 Material clamp
1 Plastic bag containing:
4 M8 locking knobs
4 M8 x 50 mushroom head bolts
4 D8 flat washers
1 Locking grommet
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual prior
to operation.
• Remove the saw from the packaging material carefully.
Description (fi g. A1–A8)
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
A1
1 On/off switch (bench saw mode)
2 Table release lever
3 Rotating table clamp
4 Mitre saw table
5 Rotating table
6 Fence right-hand side
7 Fence left-hand side
8 Rotating table location plunger
9 Mitre scale/table insert
10 Dust extraction adapter
11 Fixed upper blade guard
12 Moveable lower blade guard
13 Guard release lever
14 Operating handle
A2
14 Operating handle
15 Trigger switch (mitre saw mode)
16 Riving knife storage
17 Push stick storage
18 Leg
19 Foot
20 Table locking device
21 Saw table retention bracket
E NG L I S H
35