Flush Mounting - Veratron VL FLEX 52 Bedienungsanleitung

FLUSH MOUNTING

The recommended panel thickness is 1.5 to 3 mm. The drill hole must have a diameter of 48.1 mm. [A]
Ensure that the installation location is level and has no sharp edges.
• Do not drill holes or ports in load-bearing or stabilizing stays or tie bars!
• Note the necessary clearance behind the drill hole or port at the installation location. Required mounting depth: 65 mm.
• Drill small ports; enlarge and complete them, if necessary, using taper milling tools, saber saws, keyhole saws or files.
Deburr edges. Follow the safety instructions of the tool manufacturer.
1. Create a circular hole in the panel considering the
device dimensions. [A]
2. Remove the spinlock.
3. Gently remove the bezel using a screwdriver. [B]
Note: the bezel cannot be used after removal since
damaged.
4. Place the flush mount seal A2C53215640 (not
included) on the instrument glass.
A
C
WARNING
5. Put the instrument into the drill hole from the back [C].
6. Adjust the instrument so that the gauge is level and
fasten it to the stud bolts on the rear side of the panel,
using the flush mount fixing bracket A2C59510864
(not included) [D].
7. Insert the connector.
B
D
INSTALLATION
B000882