Assembling Instructions - FLORABEST FRT 450 B2 Originalbetriebsanleitung

use the device if the cable is damaged
or worn. Damaged mains power cables
increase the risk of electric shock.
• Always keep the extension cable well
away from the cutting tools.
Should the power cable become dam-
aged during work, then instantly discon-
nect the power cable from the mains.
DO NOT TOUCH THE POWER CABLE
BEFORE IT HAS BEEN DISCONNECT-
ED FROM THE MAINS! Risk of electric
shock.
• If the power cable for this equipment is
damaged, it must be replaced with a
special power cable, which is available
from the manufacturer or a customer ser-
vice agent of the same.
• Check that the mains voltage is the same
as indicated on the rating plate.
• Wherever possible connect the equip-
ment to a power socked with a residual-
current circuit breaker that has a rated
current of not more than 30 mA.
• Protect the equipment from moisture. The
equipment must not be moist nor oper-
ated in a moist environment. Water entry
into the equipment increases the risk of
electric shock.
• Avoid body contact with earthed parts
(e.g. metal fences, metal posts). There is
an increased risk of electric shock if your
body is earthed.
• Only use extension cables with a maxi-
mum length of 75 m that have been ap-
proved for open-air use. The stranded
cord diameter of the extension cable must
be at least 2.5 mm
ble drum to its full length so that the entire
cable can be inspected for damage.
• Never pass an operating equipment
over the extension cable. Ensure that the
power cable is always trailing behind
the operator. The extension cable can be
accidentally severed.
. Always unreel a ca-
2
• Use the envisaged cable suspensions
when attaching an extension cable.
• Never carry the equipment by its power
cable. Never pull the cable to disconnect
the plug from the mains socket. Protect
the cable from heat, oil and sharp
edges. The mains power cable could be
damaged.

Assembling instructions

Always disconnect the plug before
working on the trimmer and wait
until the cutting lines have com-
pletely stopped. There is the danger
of electric shock and the possibility
of injury by the cutting lines.
Only use original parts and
always observe the line cut-
ter during assembly work
as the line cutter (
cause series injury!
You can assemble the protection
cover with or without a spacer.
Assembling the two-part
protection cover:
1. Position the ends of the spacing
bow (10) in the guides provided
on the black section of the protec-
tion cover (8b).
2. Plug together the grey (8a) and
black (8b) sections of the protec-
tion cover.
Assembling the protection
cover and spacing bow:
3. Place the two-part protection
cover (8a+8b) and spacing bow
(10) on the motor head (7).
Ensure that the cutting strings are
not clamped in.
GB
14) can
51