Function „Pairing - Renkforce 808578 Bedienungsanleitung

Function „Pairing"
Each radio camera must be logged on to the DVR; otherwise, reception of the AV signal of the radio camera
is not possible.
This login process is also called „Pairing".
Each radio camera can be logged on to only one DVR for reasons of safety. It also is not possible
to play back the AV signal of a radio camera on two DVRs.
Only one radio camera can be logged on to each channel of the DVR. If a radio camera has al-
ready been registered at a channel, a new registration of a new radio camera will overwrite the
present one.
Since only 10 seconds are available for logging on for reasons of safety, the DVR and radio camera should
be in direct proximity to each other. Alternatively, the login process must be performed with a second
person.
Proceed as follows:
• Use the buttons „4" and „6" to choose the submenu „Pairing" and then push the button „PLAY/ENTER"
on the DVR or the button „
• Use the buttons „4" and „6" to pick one of the four channels now.
• Push the button „PLAY/ENTER" on the DVR or „
ting down from 10 to 0.
Within these 10 seconds, the square button in the housing (16) in the radio camera's cable must be pu-
shed briefly (about 1 second).
If the radio camera was recognised properly, „Pair Success" (= pairing process successful) appears and
then the camera screen.
If the radio camera is not found (e.g. out of range or the button is not pushed within 10 seconds), „Pair
Fail" appears (= pairing failed).
• In case of a failed login process, restart it (select one of the four channels with „8" and „2" and con-
firm with the button „PLAY/ENTER" on the DVR or the button „
• If the login process is to be interrupted, push the button „MENU/ESC" on the DVR or the button „MENU"
on the IR remote control repeatedly to return to the respective previous menu or leave the OSD menu.
" on the IR remote control.
" on the IR remote control to display the time coun-
" on the IR-remote control).
55