Basic Functions; Switching On/Off; B) Calling/Leaving Osd Menu; Setting The Volume - Renkforce 808578 Bedienungsanleitung

10. Basic Functions

a) Switching On/Off
Switch the DVR on or off, with the slider (1) at the rear of the DVR („ON" = activated, „OFF" = deactiva-
ted).
The radio cameras cannot be switched on or off. They work permanently if the power is connec-
ted.

b) Calling/Leaving OSD Menu

Briefly push the button „MENU/ESC" on the DVR or the button „MENU" on the IR remote control. Then the
OSD menu is displayed.
To leave the OSD menu, also briefly push the button „MENU/ESC" on the DVR or the button „MENU" on the
IR remote control (several times if required, if the DVR is in a submenu).
c) Setting the Volume
As a special feature, the small housing (16) in the radio camera's cable holds a microphone. The radio
camera therefore not only shows the image of the monitored area, but also permits hearing monitored
sound.
The playback volume can be set at the DVR or the IR remote control:
„8 V+" button on the DVR or „8" button on the IR remote control = increase volume
„2 V+" button on the DVR or „2" button on the IR remote control = reduce volume
If the radio camera is operated too close to the screen/DVR (e.g. for testing at initial commissio-
ning or when logging the radio camera on to the screen), there may be a feedback and whistling
sound. Then reduce the volume as described above.
The volume cannot be set in zoom mode, since the arrows are used to move the visible section of
the screen here. If required, briefly switch to the quad or auto mode (see chapter 10 e) by pushing
the button „PLAY/ENTER" on the DVR or the button „
the volume as desired.
" on the IR remote control and then set
51