Meec tools 017934 Bedienungsanleitung Seite 33

TROUBLESHOOTING
Problem
The motor will not start.
The fed material is not pulled
in.
Cause
The safety switch has tripped.
Power supply fault.
The material has fastened in
the infeed tray.
Material too soft.
Action
Reset the switch.
Check the power cord, plug,
power point, RCD and fuse.
Switch off the product.
Pull out the material from
the infeed opening. Start the
product again and feed in thick
branches in such a way that
the blade does not grip in the
same place.
Feed in wood or dry branches.
First press the O button and
then the I button. If the
product does not start, follow
the instructions in the section
on overload protection.
EN
33