Connecting The Onlite Bri Remote Display - Zumtobel NBOX Montageanleitung

4.8

Connecting the ONLITE BRI remote display

Application area
ONLITE BRI is a device with 3 status LEDs for remotely displaying the operating status of an emergency lighting
system. The voltage for the ONLITE BRI remote display is supplied via the system bus.
Connecting the ONLITE BRI remote display
Attention
When mounting and installing the device the voltage supply must be disconnected and the battery
fuse removed, including the supply to the phases to be monitored.
Note
i
When selecting the installation location, ensure that the screws on the housing will be easily
accessible even after installation. Observe the maximum line length for the system bus.
For more information see Section
1. Remove the screws on the right and left of the housing.
2. Remove the device cover.
3. On-wall mounting: fix the rear side of the device directly to a smooth surface using
– or –
3. Concealed box mounting: fix the rear side of the device to a recessed socket using
nBox, Installation instructions 1.0 | 02.2021 | en
Line lengths
two screws.
two screws.
44
Mounting and installation
29