Draining Black Water - Zodiac MEDLINE 9 Bedienungsanleitung

V-4-3

Draining black water

V-4-3-1
Open the large black water drain valve (7), located in the utility cabinet behind the toilet, by
-
turning the handle a quarter turn,
Press the switch (6) located on the utility cabinet panel. Hold down until the tank is empty,
-
Remember to close the valve (7) once the tank is empty.
-
V-4-3-2
Use the harbour pumping system (contact the harbour master's office for more information):
Open the deck fill (9) marked "waste",
-
Insert the pump-out nozzle into the opening,
-
Pump until the tank is empty,
-
Close the deck fill when finished.
-
INSTALLATION AND CIRCUIT
Draining at sea
Draining when docked
- FOR HYGIENE REASONS, REMEMBER TO HAVE THE CARBON FILTER
CONNECTED TO THE BLACK WATER TANK VENT CHECKED ANNUALLY.
- AFTER EACH USE, RINSE THE SYSTEM: FILL THE TANK WITH
FRESHWATER OR SEAWATER, AND THEN DRAIN.
- CLEAN USING STANDARD HOUSEHOLD CLEANING PRODUCTS.
- THE SYSTEM MUST NOT BE DRAINED IF THE BOAT IS PARKED IN SUB-
ZERO TEMPERATURES.
WARNING!!!
NEVER DISCHARGE THE CONTENTS OF THE RETENTION TANKS WHEN
NEAR THE COAST, USE THE PUMPING SYSTEMS IN HARBOURS OR
MARINAS TO EMPTY THE RETENTION TANKS BEFORE LEAVING
HARBOUR.
MAKE SURE THAT TANK DRAIN VALVE IS CLOSED IN ORDER TO
PREVENT ANY INADVERTENT DISCHARGE.
REMEMBER TO OPEN THE WASTEWATER DISCHARGE VALVE BEFORE
USING THE ELECTRIC PUMP TO DISCHARGE WASTE INTO THE SEA.
WARNING
AVOID RUNNING THE PUMP WHEN THE TANK IS EMPTY.
Page 46 / 63
Issue 4