Meec tools 020652 Bedienungsanleitung Seite 48

EN
Fence
Make sure when bevel sawing that the blade
does not come into contact with the fence.
To ensure safe use the fence should always be
used. Do not make any modifications to the
fence.
Workpiece clamp
The workpiece should always be firmly
clamped with the supplied clamp.
HOW TO USE
Locking pin
The saw head should always be locked in its
lowered position during transport and storage.
To release the saw head, first press the power
switch lock (17) to the left. Release the saw
head by pressing down to the control handle,
pulling out the locking pin (2) and allowing
the saw head to slowly move up. Never use
the product when the saw arm is locked in the
lower position with the locking pin.
Transport
1. The saw head should be locked in its
lowered position during transport.
2. Check that the knobs to lock the mitre and
bevel angle are tightened.
3. Check that the plug is unplugged and that
the power switch is switched off.
4. Only lift the product with the control
handle (3) or the outer casting parts.
Never lift the product with the guard.
Lower the saw arm and lock it in its bottom
position by pressing in the locking pin (2).
Saw table locks
The saw table locks (15) are used to lock the
saw table to the required mitre angle.
48
The mitre angle can be adjusted from 0–45°
both to the left and right. To adjust the mitre
angle, release the saw table locks and turn the
saw table to the required angle.
Bevel angle lock
The bevel angle lock (7) is used to lock the
blade to the required bevel angle. The bevel
angle can be adjusted from 0–45° to the left.
Adjust the bevel angle by releasing the bevel
angle lock and moving the saw arm to the
required bevel angle.
Spindle lock button
The spindle lock button (18) is used to lock the
spindle so that the blade cannot rotate. Press
the spindle lock button when dismantling,
replacing and fitting the blade.
Movable lower blade guard
The lower blade guard (5) protects both sides
of the blade. When the blade is lowered into
the workpiece, the blade guard lifts up over the
top blade guard (4).
Starting and switching off
1. Start the product by pressing the power
switch (16) and keeping it pressed.
2. Switch off the product by releasing the
power switch (16).
Adjusting the table at right angles
to the blade
1. Switch off the product and pull out the
plug.
2. Lower the saw arm (1) to its lowest
position and press in the locking pin
(2) to lock the saw arm in the transport
position.
3. Loosen the saw table locks (15).