Accessories - Meec Tools 020652 Bedienungsanleitung

16. Power switch
17. Power switch lock
18. Spindle lock button
19. Hex key 6 mm
20. Dust bag
21. Dust extraction port
22. Clamp
23. Fence fastener
24. Saw blade
FIG. 1

ACCESSORIES

The following accessories are supplied as
standard.
• Blade (installed)
• Hex key 6 mm
• Clamp
• Dust bag
• Instruction manual
Only use blades with a diameter that
corresponds to the markings on the power
tool.
Only use blades that are marked with at least
the same high speed as specified on the power
tool.
USE
IMPORTANT:
Check that the mains voltage corresponds
to the rated voltage on the type plate. Pull
out the plug, switch off the product and wait
until all moving parts have stopped before
adjusting, maintenance and/or replacing
accessories.
PREPARATIONS AND MOUNTING
WARNING!
Do not plug in the plug until all parts have
been fitted, otherwise there is a risk of
serious personal injury. Pull out the plug
before service, adjusting, changing the blade,
and when the product is not in use.
Dust extraction port
The product has a dust extraction port to which
the supplied dust bag can be connected. Push
the dust bag onto the dust extraction port on
the top blade guard.
To empty the bag, remove it from the dust
extraction port and open the zip.
For dust extraction to be effective the dust bag
should be emptied when it is 2/3 full.
Mounting hole
To ensure stability and safety the product
should be screwed to a stable and horizontal
surface (workbench or equivalent) with 4
screws (sold separately).
The product base has 4 holes for this.
Fasten the product as instructed below.
1. Place the product on the surface to which
it is to be fastened and mark out the
position of the mounting holes.
2. Drill 4 holes for the retaining screws.
3. Put the product on the surface and align
its mounting holes to the drilled holes. Fit
the screws, washers and nuts.
IMPORTANT:
Only install the product on a flat, stable
surface, otherwise there is a risk of
malfunctioning.
EN
47