Technical Data - Meec tools 017936 Bedienungsanleitung

EN
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
Warning danger!
Wear ear protection
Wear safety glasses.
Use a face mask.
Safety class II
Electrical safety!

TECHNICAL DATA

Rated voltage
Output
Strokes
Cord length
Weight
Sandpaper size
Sound power level, LwA
Sound pressure level, LpA
Vibration level
Always use ear protection!
The declared values for vibration and noise,
which have been measured according to a
standardised test method, can be used to
compare different tools with each other and
for a preliminary assessment of exposure. The
measurement values have been determined in
accordance with EN 62841-2-4:2014.
WARNING!
The actual vibration and noise level when
26
230 V ~ 50 Hz
150 W
11700/min
1.8 m
1.4 kg
240 x 90 mm
87 dB(A), K= 3 dB
76 dB(A), K= 3 dB
7 m/s , K=1.5 m/s
2 2
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
The oscillating sander is intended to work with
sandpaper.
1. Power switch
2. Lock button
3. Extractor adapter
4. Clips for sandpaper
5. Pad for sandpaper
FIG. 1
USE
FASTENING SANDPAPER
1. Open the paper clips (4).
2. Place a sheet of sandpaper with a suitable
grade on the pad (5). Make sure that the
perforations on the paper and the pad are
in alignment.
FIG. 2
3. Pull both ends of the paper through the
edge of the pad.
4. Fasten the paper with the clips and
check that both ends are firmly fixed.
The sandpaper should fit firmly so that it
cannot come loose.
FIG. 3