Technical Data - Meec tools 018633 Bedienungsanleitung

TECHNICAL DATA

Rated voltage
Output
Speed, no load
Safety class
Protection rating
Disc diameter
Spindle diameter
Spindle length
Cord length
Sound power level, L
wA
Sound pressure level, L
Vibration level, a
,
h AG
Always wear ear protection!
The declared values for vibration and noise, which
have been measured according to a standardised
test method, can be used to compare different
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN 60745-2-3:2011.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
Angle grinder för cutting, grinding and
polishing. Disc sold separately.
230 V ~ 50 Hz
2000 W
6500 rpm
IP20
Ø 230 mm
M14
90 mm
3 m
91.8 dB(A), K= 3 dB
102.8 dB(A), K= 3 dB
pA
5.122 m/s², K=1.5 m/s²
Parts
1. Power switch
2. Start inhibitor
3. Support handle
4. Guard
II
5. Disc
6. Clamp screw for guard
7. Spindle lock button
FIG. 1
Supplied
• Angle grinder
• Guard
• Support handle
• Pin spanner for fitting disc
• Carbon brushes (2)
• Instructions
ASSSEMBLY
FIT SUPPORT HANDLE
The support handle can be fitted on the left
side (1) of the product, over the product (2) or
on the right side (3) of the product.
FIG. 2
• Screw the support handle firmly in place
on one of the threaded holes on the
product.
Grinding accessories
• The table specifies the requisite speed/
cutting speed for grinding accessories.
• Always check the maximum permissible
speed or peripheral speed for the grinding
accessory.
• Always use the supplied shims together
with grinding accessories. They are placed
between the grinding accessory and the
flange nut and must have as a minimum
EN
43