Lavor TUCSON XL Montageanleitung Seite 22

EN
ELECTRICAL CORD
• WARNING:
Take care not damage the electric
cable. Have a damaged power cord replaced im-
mediately by an authorized service point or an
electrical specialist.
> ELECTRIC DIAGRAM
See illustrations, pag. 118.
> WATER DIAGRAM
See illustrations, pag. 118.
WARRANTY CONDITIONS
All our machines are subjected to strict tests
and are covered against manufacturing defects
in accordance with applicable regulations. The
warranty is effective from the date of purchase.
The following are not included in the warranty:
Parts subject to normal wear. - Rubber parts, charcoal,
filters and the accessories and optional accessories.
- Accidental damage, caused by transport, neglect
or inadequate treatment, incorrect or improper use
and installation failing - The warranty shall not cover
any cleaning operations to which the operative
components may be subjected, such as clogged
nozzles and filter blocked due to limestones.
> DISPOSAL
As the owner of electrical or electronic
equipment, the law (in accordance with the EU
Directive 2012/19/EU on waste from electrical
and electronic equipment and the national laws
of the EU Member States that have implemented this
Directive) prohibits you from disposing of this product
or its electrical / electronic accessories as municipal solid
waste and obliges you to make use of the appropriate
waste collection facilities. The product can be disposed
of by returning it to the distributor when a new product
is purchased. The new product must be equivalent to that
being disposed of.
Disposing of the product in the environment can cause
great harm to the environment itself and human health.
The symbol in the figure indicates the urban waste
containers and it is strictly prohibited to dispose of the
equipment in these containers. Non-compliance with the
regulations stipulated in the Directive 2012/19/EU and the
decrees implemented in the various EU Member States is
administratively punishable.
> REPAIRS - SPARE PARTS
For any problems not mentioned in this manual, or if
the machine breaks down, you are urged to con-
Authorized After-Sales Service
tact an
relative repair or for any replacement of compo-
nents with original spare parts. Use exclusively
original replacement parts.
TROUBLESHOOTING
Before doing any work on the machine, disconnect
the electricity and water supplies and discharge the
pressure. Proceed systematically to identify faults
following the chart below; if you are still unable to
eliminate the problem, call in the
Sales Service.
Fault
-
Cause
Repair
Fault
Cause
Repair
22
Authorized After-
When switch "ON" the ma-
chine will not start wor-
king
- Plug not properly inserted in
socket.
- Electric socket is faulty.
- The main voltage is insufficient.
- The pump is stuck.
- Gauge of extension lead not
sufficient.
- Fit plug in power socket cor-
rectly.
- Have electrical socket checked.
- Have a check made on the suit-
ability of the mains system.
- Turn switch to ON while keep-
ing nozzle trigger pressed; if
problem persists, contact an
authorised service centre.
- Refer to maintenance section.
The motor stops suddenly
- Thermic safety switch has
tripped due to the overheating.
- Cable extension seems to be
inadequate.
- Leave motor to cool for a few
minutes. If the problem per-
sists, contact an authorised
service centre.
- Refer to maintenance sec-
tion.
for the