JUNO JB121D0 Benutzerinformation Seite 45

8.4 How to set: End Time
1. Set a heating function and temperature.
2. Press again and again until
to flash.
3. Press or
press . First you set the minutes and
then the hours.
When the set time ends, the signal sounds for
2 minutes. The display shows flashing
the time setting . The oven turns off
automatically.
4. Press a sensor field to stop the signal.
5. Turn off the oven.
8.5 How to set: Time Delay
1. Set a heating function and temperature.
2. Press again and again until
to flash.
3. Press or
Duration.
4. Press .
5. Press or
Duration.
6. Press .
The display shows flashing
7. Press or
press . First you set the minutes and
then the hours.
The oven turns on automatically later on,
works for the set Durationand stops at the set
End Time. When the set time ends, the signal
sounds for 2 minutes. The display shows
flashing and the time setting . The oven
turns off automatically.
8. Press a sensor field to stop the signal.
9. Turn off the oven.
When the Time Delay function is
turned on, the display shows a symbol of
the heating function,
. The dot shows which clock function is
on in the Clock / residual heat display.
starts
to set the End Time and
starts
to setthe minutes for
to set the hours for
.
to set the End Time and
with a dot and
8.6 How to set: Set + Go
You can use the Set + Go function only when
the Duration is set.
1. Set a heating function and temperature.
2. Set the Duration.
3. Press
shows flashing
4. Press
and
The display shows
indicator. This indicator shows which clock
function is activated.
5. Press a sensor field (apart from ON /
OFF) to start the Set + Go function.
8.7 How to set: Minute Minder
1. Press
The display shows flashing
2. Press
you set the seconds, then the minutes
and the hours.
3. Press
and to confirm.
4. Press
automatically after 5 seconds.
When the set time ends, the signal sounds for
2 minutes and the display shows flashing
00:00 and
5. Press a sensor field to stop the signal.
8.8 How to set: Count Up Timer
1. To reset the Count Up Timer press:
again and again until display shows
flashing
2. Press and hold:
shows "00:00" the Count Up Timer starts
to count up again.
again and again until the display
.
to set the Set + Go function.
and with an
.
and "00".
to switch between options. First
or to set the Minute Minder
or the Minute Minder starts
.
.
. When the display
ENGLISH 45