Using An Optional Abutment Holder; Operating The Blank Changer - VHF S5 Originalbetriebsanleitung

S5 – Operation: Preparing jobs
F . 25 S
IG CREWING DOWN THE SCREW TO IMMOBILIZE THE BLOCK
You can now mount the block holder.

6.4.2 Using an optional abutment holder

With an optional abutment holder, your machine can
process prefabricated abutments with prefabricated
connection geometries.
Abutment holders for common abutment
systems can be obtained from customer
service.
You can find more information about abutment
holders and abutment blanks at the following internet
address:
dentalportal.info/abutments

6.4.3 Operating the blank changer

You can mount up to 8 blanks to the magazine slots of
the blank changer. The machine automatically loads
blanks into the working chamber when they are
required for the next job. This allows you to process up
to 8 jobs in succession without having to start each job
manually.
and blank gripper
If you reach into the blank magazine while the blank
magazine or blank gripper is moving, you may suffer
from bruises.
To the left of each blank magazine slot is a laser
engraved number labeling the corresponding slot.
F
IG
INDICATE THE SLOTS THEY CORRESPOND TO
Original Operating Instructions: S5
Version: 12/15/2021
Crushing hazard caused by
CAUTION
the moving blank magazine
Before moving the blank magazine via DENTALCNC,
remove your hands from the blank magazine and
close the blank magazine door.
While the machine is operating, always expect the
blank magazine to suddenly start moving.
When you are working in the blank magazine while
the machine is operating, always keep your hands at
the change position and never reach into the blank
magazine.
If you manually move the blank magazine, ensure
that you do not pinch your fingers.
. 26 T (
HE BLANK MAGAZINE SLOT NUMBERS MARKED ORANGE
The blank types in the physical slots must cor-
n
respond to the blank types which are assigned to
the virtual slots in DENTALCNC.
To move the blank magazine or to manually load
n
blanks into the working chamber, use the Machin-
ing view in DENTALCNC.
EN 29
,
ARROWS
)