VHF S5 Originalbetriebsanleitung Seite 31

S5 – Operation: Preparing jobs
F . 30 R (
IG ECESSES MARKED ORANGE
MARKINGS FOR SAFER REMOUNTING
e. Close the fixing brackets of the blank frame
(marked blue) and screw in the fixing screws
(marked orange).
F . 31 C
IG LOSING THE FIXING BRACKETS OF THE BLANK FRAME
The disc is mounted to the blank frame.
5. (Optional) To mount a disc to a QuickFrame, do the
following:
The QuickFrame is a blank frame that uses
magnets to fixate the blank. It is suitable for
PMMA and zirconia discs with a disc rim
height of 10 to 10.3 mm.
The QuickFrame is available from customer
service.
a. Place the blank frame on an even surface.
b. With one hand hold the blank frame and the
mounted disc (if any).
The blank frame cover is held in place
by magnets. When you remove the
cover, the blank is no longer secured
and may fall out when you tilt the
blank frame.
c. To remove the blank frame cover, tilt it side-
wards with your other hand. Use the recess
)
TO BE ALIGNED WITH
Original Operating Instructions: S5
Version: 12/15/2021
(marked blue) on the left and right side of the
cover.
F . 32 R
IG EMOVING THE BLANK FRAME COVER
d. Remove any object from the blank frame.
NOTICE
machining results due to improper blank
fixation
If you do not properly clean the blank frame
and especially the magnets or if you do not
correctly place the blank frame cover, the
blank may not be properly fixated. As a
result, the machine and tools may get
damaged and the machining results may not
be satisfactory.
Before placing a disc, thoroughly clean
the blank frame, especially the magnets,
positioning pins and recesses.
Always place the blank frame cover so
that it fits the positioning pins and is flush
with the bottom part of the blank frame.
e. Clean the bottom part and the cover of the
blank frame with a cloth. Especially clean the
magnets (marked green), positioning pins
(marked orange) and recesses (marked blue).
Use a mild cleaning agent if necessary.
F . 33 C
IG LEANING THE BLANK FRAME
,
POSITIONING PINS MARKED ORANGE
EN 31
Damages to the
machine or bad
; ,
MAGNETS MARKED GREEN
RECESSES MARKED BLUE