Technical Data - Steinbach Classic 250N Active Balls+ Originalbetriebsanleitung

Problem
Air bubbles escape from the
injection nozzle.
The pump is not getting enough
water or the system pressure is too
low.
The pump does not start up.
There is filter medium in the pool
If the problem cannot be solved, contact the customer service listed on the last page.

Technical data

Model:
Item number:
Vessel volume:
Connection diameter:
Design:
Circulation rate:
Pool volume (water
content):
Water temperature:
Requirements for filter
medium:
Steinbach filter balls:
Quartz filter sand:
Possible cause
The pump is sucking in air.
The water level in the pool is too
low.
The prefilter basket (if present)
is clogged.
The suction line is out of place
or clogged.
The pump has no power.
The pump is defective.
Quartz filter sand was topped
up.
Defective screens in the filter
vessel.
Classic 250N +
Active Balls+
040385/040386
Ø 250 mm / approx. 12 l
Ø 32/38 mm
7-way valve with
manometer
max. 3,900 l/h
max. 19,000 l (10,000 gal) Prefilter:
max. 35 °C
approx. 300 g
approx. 10 kg;
0.7-1.2 mm;
DIN EN 12904
Remedy
Check all hoses and gaskets for leaks.
Retighten the hose clamps.
Check the water level in the pool and fill
with more water if necessary until the
pool water covers the suction line
connection completely.
Raise the water level in the pool.
Empty the prefilter basket.
Clean the pressure line.
Connect the pump's power plug to the
power supply. Check whether the fuse
has tripped.
Contact customer service.
Backflush the system until the water runs
clear. See section "Backflushing".
Check the screens for damage and
replace if necessary.
Pump model:
Pump item number:
Pump installation:
Pump function principle:
Pump timer:
Battery for timer:
Power supply:
Output:
Flow rate:
Delivery head:
CPS 40-2
040955
on base plate
not self-priming
- - - - -
- - - - -
- - - - -
220-240 V~, 50 Hz
max. 200 W
max. 4,500 l/h
max. 6.5 m
33