General Information; Read And Keep The Operating Instructions; Intended Use; Explanation Of Symbols - Steinbach Classic 250N Active Balls+ Originalbetriebsanleitung

General Information

Read and keep the operating instructions

These operating instructions are a part of this filter system (in the following also called
"device"). It contains important information about start-up and operation.
Read the operating instructions and especially the safety instructions carefully before using
the device. Non-observance of these operating instructions can lead to severe injuries or
damage to the device.
Keep the operating instructions for further use. If you pass on the device to a third party, you must pass
on these operating instructions as well.

Intended use

This device has been designed exclusively for cleaning pool water. It can be used in salt water as long
as the salt content of the water is less than 0.5% (salt electrolysis). It removes visible dirt and is suited
for all standard pools with a hose connection of Ø 32/38 mm.
The filter medium in the filter tank filters dirt particles out of the flowing water and serves as permanent
dirt and floating debris filter for your pool water. The cleaned water flows back into the pool via the 7-
way valve and the return line.
Use exclusively quartz filter sand that meets the
DIN EN 12904 directive as filter medium. Alternatively, use Steinbach Filter Balls. Please refer to the
section "Technical data" for the required quantities.
This product is exclusively intended for private use and not suited for the commercial sector. Only use
the device as described in these operating instructions. Any other use is considered inappropriate and
may lead to material damage or even injury. The device is not a toy.
The manufacturer or retailer will not assume any liability for damage caused by inappropriate or
incorrect use.

Explanation of Symbols

The following symbols are used in these operating instructions, on the device or on the packaging.
Here you will find useful additional
information.

Safety

The following signal words are used in these operating instructions.
WARNING!
CAUTION!
NOTICE!
Risk of damage!
Do not open the packaging with sharp
or pointed objects, such as cutters.
This signal symbol/word denotes a hazard with an average
risk level that could lead to death or severe injury if it is not
avoided.
This signal symbol/word denotes a hazard with a low risk
level that could lead to mild or moderate injury if it is not
avoided.
This signal word provides a warning about potential material
damage.
23