Troubleshooting - Blumfeldt Flagranti Bedienungsanleitung

TROUBLESHOOTING

If the problem is:
Pilot won't light .
Pilot won't stay lit.
Burner won't light..
Burner flame is low .
Note: Do not operate the
appliance below 5 °C (40 °F).
And this condition exists:
Cylinder valve is closed
Blockage in orifice or pilot
tube
Air in the gas line
Low gas pressure
Dirt build up around pilot
Connection between gas
valve and pilot assembly
is loose
Bad thermocouple
Dirt build up around pilot
Connection between gas
valve and pilot assembly
is loose
Bad thermocouple
Gas pressure is low
Outdoor temperature is
greater than 5 (40°F) and
tank is less than 25% full
Supply hose is bent or
kinked
Control knob is fully " ON"
Then do this:
Open valve
Clean or replace orifice or
pilot tube
Open gas line and bleed
it (pressing control knob
in) for not more than 1-2
minutes or until you smell
gas
Gas cylinder low or empty
Clean dirt from around
pilot
Tighten connection and
perform leak test
Replace thermocouple
Replace gas cylinder
Clear blockage
Turn control knob to "ON"
position
Replace gas cylinder
Replace gas cylinder
Straighten hose and
perform leak test on hose
Turn control knob to
"OFF", let it cool to room
temperature and check
burner and orifices for
blockage
EN
43