Connecting To A Gas Cylinder - Blumfeldt Flagranti Bedienungsanleitung

EN
38

CONNECTING TO A GAS CYLINDER

• Use max. 13 kg gas cylinder. Please refer to your gas supplier for suitable
gas cylinder. The gas bottle may have a diameter of max. 32 cm and a
height of max. 60 cm.
• Refer to your gas supplier for instructions on the use of your gas cylinder.
• Only change gas cylinders outdoors or in a well ventilated area away from
naked fl ames and any other source of ignition.
• The gas cylinder must always be used in an upright position.
• Close the appliance control knob by turning fully clockwise.
• Close the gas cylinder tap and then attach the regulator onto the gas
cylinder.
• Tighten all connections fi rmly and with a spanner where appropriate. The
cylinder should be located on the cylinder base.
• Check for leaks at all joints using soapy water. If a leak is found, tighten the
joint and then re-test
WARNING
Danger of Explosion
Never use a naked fl ame to check for leaks. Never leak test
while smoking.
The gas connections on this appliance are leak tested at the factory prior to
shipment.
This appliance needs to be periodically checked for leaks and an immediate
check is required if the smell of gas is detected.
• Make a soap solution using 1 part of liquid dish-washing soap to 3 parts
water. The soap solution can be applied with a soap bottle, brush, or rag to
the leak tested points shown in the fi gure above.
• The valve of the gas cylinder should be in the OFF position at this point of
the leak test. Once the soapy solution is applied to the gas connections,
the valve of the gas cylinder needs to be turned to the ON position.
• Soap bubbles will begin to form in the soapy solution if a leak is present.
• In case of a leak, turn off the gas supply. Tighten any leaking fi ttings, then
turn the gas supply on and recheck.