Blumfeldt Flagranti Bedienungsanleitung Seite 28

EN
28
• Do not use or store flammable materials near this appliance.
• Do not spray aerosols in the vicinity of this appliance while it is in
operation.
• Always maintain at least 1m clearance from combustible materials.
• Always position the appliance on a firm level surface.
• The cylinder must be stored outdoors or in a well ventilated area.
• Storage this appliance indoors is permissible only if gas cylinder is
disconnected and removed from the appliance.
• The appliance must be installed and gas cylinder stored in accordance with
local gas fitting regulations.
• The hose assembly must be replaced prior to the appliance being put
into operation if there is evidence of excessive abrasion or wear, or if the
hose is damaged, and that the replacement hose assembly shall be that
specified by the manufacturer.
• Shut off the valve at the gas cylinder or the regulator before moving the
appliance.
• To close the gas supply at the valve of the gas cylinder or the regulator
after use.
• Checking the tubing or the flexible hose per month and each time the
cylinder is changed.
• The regulator & hose assembly must be located out of pathways where
people may trip over it or in area where the hose will not be subject to
accidental damage.
• The glass window is a hot part Do not touch it while it is working!
• In case of hotplate glass breakage, shut off all burner and any heating
elements and isolate the appliance from the power supply.
• Do not touch the appliance surface.
• Do not use the appliance before leakage test.
• The injector is not removable and it is forbidden to convert from one gas
pressure to another.
• Do not connect the gas cylinder directly to the appliance without
regulator.
• The tubing or the flexible hose must be changed within the prescribed
intervals.
• Use only the type of gas and the type of cylinder specified in these
instructions.
• This appliance must be used, and the gas cylinder stored, in accordance
with the regulations in force.
• Do not block the pilot box and the burner when filling heating parts on the
burner.