Sun Microsystems Netra t1 LOMlite Arbeiten Seite 7

The following commands can be sent to the LOMlite device when it is connected:
LOMlite Commands
TABLE 1
Command Use
alarmoff n Set alarm n off. n can be 1, 2 or 3
alarmon n Set alarm n on. n can be 1, 2 or 3
Reset monitoring to report all failures
check
Return control of the serial connection to the console
console
Display the status of the fans, power supply, alarms and fault LED
environment
Set the Fault light to on
faulton
Set the Fault light to off
faultoff
Display the list of LOMlite commands
help
Power the system on
poweron
Power the system off
poweroff
Reset the system
reset
Show the system model
show model
Show the system name (equivalent to uname -n)
show hostname
Show the event log
show eventlog
Show the current LOMlite escape sequence
show escape
Show all the information available with the show command
show
Show the version number of the LOMlite device
version
Commands can be abbreviated to a minimum of two unique characters.
By default the LOMlite reports any event that it detects over the serial connection.
This can corrupt the console information when the console is connected to the serial
connector. You can turn off the LOMlite reporting either by editing the driver
configuration file or using the lomctl utility.
To turn off reporting using lomctl, enter the following:
# lomctl serialeventsoff
Using the Netra t1 LOMlite Device 3